[mythtv-users] Hauppage Nova-T-500 losing remote on reboot
Thomas Boehm
mythtv-users at lists.boehmi.net
Mon Apr 2 08:48:09 UTC 2012
Giles wrote:
> Difficulties in figuring the problem out were compounded by the fact the
> remote sensor seems to get lost on a reboot, and needs a cold boot to
> play nicely. The remote always shows up on:
>
>>cat proc/bus/input/devices
>
> and works fine from a cold boot. If the system is rebooted with:
>
>>sudo shutdown -r now
>
> the remote does not respond (to irw - I couldn't get the mode2 command
> to work) if the system is rebooted.
> [...]
> Has anyone had similar issues - is there a workaround? - or is this
> kernel related? Should I file a bug report?
You're lucky that it only effects the remote control. A lot of people
(including me) can't use this card after a reboot at all. Check your
syslog whether the card is found in a "warm" or "cold" state after a
reboot. If it's found in a warm state, the firmware doesn't get loaded
properly. If your card is found in a cold state, then you have a
different problem.
I don't have a solution other than always shut it down and switch it
back on. That shouldn't be more difficult than rebooting for your GF ;-)
HTH
Thomas
More information about the mythtv-users
mailing list