[mythtv-users] Sound in mythtv but no where else

[Igor Cicimov]

On Fri, Jul 20, 2012 at 10:01 AM, Igor Cicimov <icicimov at gmail.com> wrote:

> On Fri, Jul 20, 2012 at 5:58 AM, F.B. Parker <fbp.mythtv at gmail.com> wrote:
>
>>
>>
>> On Wed, Jul 18, 2012 at 5:08 PM, Jean-Yves Avenard <jyavenard at gmail.com>wrote:
>>
>>>
>>>
>>> You said HW:0,3 worked for you. So in your asound.conf or tlocal
>>> .asoundrc you add:
>>> pcm.!default {
>>>    type plug
>>>    slave.pcm "dmix:0,3"
>>> }
>>>
>>> That's it.
>>>
>>>
>> Sound works fine for me in MythTV (0.25-fixes) but occasionally sound
>> stops working in Clementine (music player) and in Firefox. (BTW, I never
>> have been able to figure out what gets it working again, but eventually the
>> sound in Clementine and Firefox will just start working again.)
>>
>> In mythtv setup, under the audio wizard my sound is set to
>>
>> ALSA:iec958:CARD=SB,DEV=0
>>
>> What would I put in asound.conf to do the equivalent of what you have
>> shown above?
>>
>> -FBP
>>
>>
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://www.mythtv.org/mailman/listinfo/mythtv-users
>>
>>
> Run "aplay -l" and note the card number and device number for your digital
> device.
>

Kevin,

Just remembered there is a pulseaudio settings tool called pavucontrol.
Install it, run it and check if the HDMI device is disabled in pulseaudio.

Igor
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.mythtv.org/pipermail/mythtv-users/attachments/20120721/0b4c5c1c/attachment.html>