[mythtv-users] NVidia/overscan problem
Jay Ashworth
jra at baylink.com
Mon Sep 23 19:13:19 UTC 2013
----- Original Message -----
> From: "Jerry" <mythtv at hambone.e4ward.com>
> Check out the second section on the wiki, entitled "With NVidia Cards
> and
> more recent nVidia drivers (greater than version 300)"
> http://www.mythtv.org/wiki/Overscan#Making_MythTV_fit_the_screen_on_a_TV
FWIW: I did find the overscan correction section of setup, and tried to
run it, but I had two separate problems:
1) At first, I couldn't find the lower-right "arrow", because it was so far
off-screen that even the triangle wasn't visible. and
2) When I did figure that out, and ran it up to where it belonged, Myth
violently overcorrected, leaving me a 20-30 px strip of desktop on bottom
and right.
Those might both be related to the scan conversion in the TV, but I'm not
betting on it.
And just to make this more complicated: when the TV is being fed the
1080i from the GeForce... it's "Display" *says* it's 720p. <sigh>
Cheers,
-- jra
--
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://baylink.pitas.com 2000 Land Rover DII
St Petersburg FL USA #natog +1 727 647 1274
More information about the mythtv-users
mailing list