[mythtv-users] Audio continues after close of program
kfoltz4 at juno.com
kfoltz4 at juno.com
Sat Feb 1 15:39:37 UTC 2014
On Jan. 30th hikavdh at gmail wrote:
> I am using MythTV with an analog capture card. The audio source is the
> CD line in port on the motherboard. MythTV plays the analog NTSC cable
> channels without problems but the audio continues after closing the
> program. How do I mute the CD line in source on exit?
> mythtv-users mailing list
> mythtv-users [at] mythtv
> http://www.mythtv.org/mailman/listinfo/mythtv-users
> If you have v4l-utils, run: "v4l2-ctl -d [your video device
> eg./dev/video0] --set-ctrl=mute=1"
> Since your card is cabled to your audio card, it might not work.
> Then you have to mute the channel in your audio-mixer.
> If you use alsa: "amixer -c [your card number] sset ['your channel
> name'] 0"
> with: "amixer -c [your card number] sget" you get the available mixer
> controls.
> Tot mails,
> Hika mailto:hikavdh [at] gmail
> "Zonder hoop kun je niet leven
> Zonder leven is er geen hoop
> Het eeuwige dilemma
? Zeker als je hoop moet vernietigen om te kunnen overleven!"
> De lerende Mens
Running "amixer set CD mute" at the command line will silence the audio. What I would prefer to do is add that command to the closing process in MythTV. How is that done? I am running MythTV on Kubuntu 12.04 if that makes any difference.
____________________________________________________________
Do THIS before eating carbs (every time)
1 EASY tip to increase fat-burning, lower blood sugar & decrease fat storage
http://thirdpartyoffers.juno.com/TGL3131/52ed1562da3be15620d7dst04duc
More information about the mythtv-users
mailing list