[mythtv-users] Enter Channel Number on Guide

Stephen Worthington stephen_agent at jsw.gen.nz
Mon Mar 3 23:40:45 UTC 2014


On Mon, 3 Mar 2014 15:31:00 -0500, you wrote:

>I noticed in the Frontend, when I bring up the EPG and type a number, it goes to that number.. For Example if I type a 2 it takes me to the 200s channels
 My Problem is when I try to type in a 4 digit number to go to my 1000s channels.
>
>If I type 1 - 2 - 3 - 2 to go to 1232 it just flips aroung between 100s, 200s, 300s etc.
>
>Is there a setting for this? If not Could a dev point me to the correct area of the code so I can poke around and see if I can code in a pause?
>Ideally it would Show the number you typed in lil 1232 while pausing for more input, then if no more input is detected within 3 seconds switch the guide to that channel.
>
>Thanks!
>
>Greg

Four digits works for me, but I have to make sure I type fast enough -
the timeout is not very long.  I normally use my keyboard, as doing it
on my remote control often makes me too slow.


More information about the mythtv-users mailing list