Having trouble with the analog part of a new HVR-2250 card. Using Gentoo and kernel 3.2.1 and it looks like the card is loading ok (below). I downloaded the firmware and put it in /lib/firmware, not sure if that is still needed. There are /dev/video0 and /dev/video1 entries and I added it using the MPEG-2 in mythtv-setup, but the card shows up on myth as "unavailable" Not sure what I need to look for at this point. I have read what I can find, does anyone have any tips on getting this to work?<br>
<br>Dan<br>
<br>
saa7164 driver loaded<br>
saa7164 0000:02:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16<br>
CORE saa7164[0]: subsystem: 0070:8851, board: Hauppauge WinTV-HVR2250 [card=7,autodetected]<br>
saa7164[0]/0: found at 0000:02:00.0, rev: 129, irq: 16, latency: 0, mmio: 0xfb800000<br>
saa7164 0000:02:00.0: setting latency timer to 64<br>
saa7164_downloadfirmware() no first image<br>
saa7164_downloadfirmware() Waiting for firmware upload (NXP7164-2010-03-10.1.fw)<br>
saa7164_downloadfirmware() firmware read 4019072 bytes.<br>
saa7164_downloadfirmware() firmware loaded.<br>
saa7164_downloadfirmware() SecBootLoader.FileSize = 4019072<br>
saa7164_downloadfirmware() FirmwareSize = 0x1fd6<br>
saa7164_downloadfirmware() BSLSize = 0x0<br>
saa7164_downloadfirmware() Reserved = 0x0<br>
saa7164_downloadfirmware() Version = 0x1661c00<br>
saa7164_downloadimage() Image downloaded, booting...<br>
saa7164_downloadimage() Image booted successfully.<br>
saa7164_downloadimage() Image downloaded, booting...<br>
saa7164_downloadimage() Image booted successfully.<br>
saa7164[0]: Hauppauge eeprom: model=88061<br>
DVB: registering new adapter (saa7164)<br>
DVB: registering new adapter (saa7164)<br>
saa7164[0]: registered device video0 [mpeg]<br>
saa7164[0]: registered device video1 [mpeg]<br>
saa7164[0]: registered device vbi0 [vbi]<br>
saa7164[0]: registered device vbi1 [vbi]<br>