Xbox DVD Dongle
From MythTV
|
This howto focuses on HOWTO get the Xbox DVD dongle to work on a standard pc. Also see XBOX_DVD_IR_Receiver
[edit]
Device information
Supported remotes:
- Xbox DVD remote (duh)
- Remotes with the rca dvd protocol
[edit]
Setup
[edit]
Wiring
Some information about wiring the DVD dongle to the pc can be found here.
[edit]
Installation
[edit]
Gentoo
If you are running Gentoo then be thankful the patch for the Xbox DVD dongle is in the portage. Add this line to /etc/make.conf
LIRC_DEVICES="xboxusb"
Now just run
# emerge lircd
Now use the config from the bottom of the page. The next thing you need to do is test to see if it works. Because it is using a new driver if you have it plugged in then you need to unplug it and plug it back in. Now start lircd
# /etc/init.d/lircd start
then run
# irw
and watch to see if your button presses are showing up!
[edit]
Configuration
...
# LIRCD configuration file for Xbox DVD Kit
#
# Marko Friedemann <mfr@bmx-chemnitz.de>
#
#
# brand: Microsoft
# model: Xbox DVD Remote
# supported devices: Xbox DVD Remote via xpad-ir driver
#
# comment: EXPERIMENTAL
#
begin remote
name XboxDVDDongle
bits 8
begin codes
SELECT 0x0b
UP 0xa6
DOWN 0xa7
RIGHT 0xa8
LEFT 0xa9
INFO 0xc3
9 0xc6
8 0xc7
7 0xc8
6 0xc9
5 0xca
4 0xcb
3 0xcc
2 0xcd
1 0xce
0 0xcf
DISPLAY 0xd5
BACK 0xd8
SKIP+ 0xdd
SKIP- 0xdf
STOP 0xe0
REVERSE 0xe2
FORWARD 0xe3
TITLE 0xe5
PAUSE 0xe6
PLAY 0xea
MENU 0xf7
end codes
end remote
MORE SOON!
