Difference between revisions of "Homemade Serial Receiver"
Colinmc151 (talk | contribs) m (Added reference to article on building a LIRC serial receiver) |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Cleanup | ||
| + | |msg=This page has broken Images. | ||
| + | }} | ||
If you can solder and can figure out what shops sell transistors then you can make your own serial receiver. There is even a list of [[Homebrew lirc reciever parts]] | If you can solder and can figure out what shops sell transistors then you can make your own serial receiver. There is even a list of [[Homebrew lirc reciever parts]] | ||
| Line 31: | Line 34: | ||
* http://www.lirc.org/receivers.html | * http://www.lirc.org/receivers.html | ||
* http://lnx.manoweb.com/lirc | * http://lnx.manoweb.com/lirc | ||
| + | * http://www.linuxjournal.com/article/8811 | ||
| − | + | [[Category:Remote Controls]] | |
| − | [[Category: | ||
Revision as of 17:18, 22 April 2008
Cleanup: This page has broken Images.
If you can solder and can figure out what shops sell transistors then you can make your own serial receiver. There is even a list of Homebrew lirc reciever parts
And what you'll be building is something like this:
And if you squish it down it can look like this:
File:Lirc closed.jpg File:Lirc end.jpg File:Lirc open.jpg File:Lirc wires.jpg
and if you have a one of the Hauppage PVRs you could use that (they look a lot neater!) :
One advantage of building it like this (with the 1.5mm stereo plug/jack) is that you have the ability to route the actual IR receiver anywhere (even another room - though I don't know what the maximum distance would be).
oh, if you want your 1.5mm jack plug to be compatible with the Hauppauge:
Base = GND Ring = signal Tip = VCC+
Someone on the (MythTV-Users) mail list claims 281 Ft using CAT5 and Hauppage IR sensor.
