Difference between revisions of "Wake-on-LAN"
(→Sending 'magic packet' to wake up your mythbox) |
|||
Line 1: | Line 1: | ||
[[Category:HOWTO]] | [[Category:HOWTO]] | ||
− | + | If you have a network card that supports wake-on-lan, you can powerup your mythbox by sending it a 'magic packet' over the network. Here's what i did (i use an Epia M10k with Fedore Core 4): | |
− | |||
== Setting up == | == Setting up == | ||
− | |||
− | |||
First, find out whether your network card supports wol: | First, find out whether your network card supports wol: | ||
# ethtool eth0 | # ethtool eth0 |
Revision as of 18:19, 12 October 2006
If you have a network card that supports wake-on-lan, you can powerup your mythbox by sending it a 'magic packet' over the network. Here's what i did (i use an Epia M10k with Fedore Core 4):
Setting up
First, find out whether your network card supports wol:
# ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 1 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000001 (1) Link detected: yes
The 'g' in Supports Wake-on: pumbg indicates that wake-on-lan by using a 'magic packet' is indeed supported. Next, you need to make sure that wake-on-lan support is enabled in the BIOS (although, this does not seem to be necessary for my motherboard). In addition, you need to tell your network card to enable wake-on-lan:
# ethtool -s eth0 wol g
Since after rebooting Wake-on will be reset, you might what to add it to /etc/rc.local:
# echo 'ethtool -s eth0 wol g' >> /etc/rc.local
Now turn off you mythbox and send it a 'magic packet'.
Sending 'magic packet' to wake up your mythbox
You will need a wake-on-lan client to send 'magic packets' over your network. First, determine the MAC address of the machine you what to power on:
# ifconfig
Turn off you mythbox and from another computer execute the following command (replacing the MAC address with the one you just found). I used a wake-on-lan client from Sourceforge.
$ wol 00:4F:49:07:0B:5F
If all went well, your mythbox will boot up now! There are other clients for Windows and Mac OS X as well.
Useful links:
- http://ahh.sourceforge.net/wol/ (wake-on-lan client + additinal information)
- http://dag.wieers.com/packages/wol/ (wol packages for RedHat and Fedora)
- http://www.die.net/doc/linux/man/man8/ethtool.8.html (man page for ethtool)
- http://www.sourceforge.net/projects/gkernel/ (gkernel package that contains ethtool)