Xbox DVD Dongle
From MythTV Official Wiki
This howto focuses on howto get the Xbox DVD dongle to work on a standard pc.
Device information
Supported remotes:
- Xbox DVD remote (duh)
- Remotes with the rca protocal ( I have not tested this yet! )
- ...
More soon
Setup
Wiring
Some information about wiring the DVD dongle to the pc can be found here.
Installation
Gentoo
If you are running Gentoo then be thankfull the patch for the Xbox DVD dongle is in the portage. Add this line to /etc/make.conf
LIRC_DEVICES="xboxusb"
Now just run
# emerge lircd
Now use the config from the bottom of the page. The next thing you need to do is test to see if it works. Because it is using a new driver if you have it plugged in then you need to unplug it and plug it back in. Now start lircd
# /etc/init.d/lircd start
then run
# irw
and watch to see if your button presses are showing up!
/etc/lircd.conf
... # LIRCD configuration file for Xbox DVD Kit # # Marko Friedemann <mfr@bmx-chemnitz.de> # # # brand: Microsoft # model: Xbox DVD Remote # supported devices: Xbox DVD Remote via xpad-ir driver # # comment: EXPERIMENTAL # begin remote name XboxDVDDongle bits 8 begin codes SELECT 0x0b UP 0xa6 DOWN 0xa7 RIGHT 0xa8 LEFT 0xa9 INFO 0xc3 9 0xc6 8 0xc7 7 0xc8 6 0xc9 5 0xca 4 0xcb 3 0xcc 2 0xcd 1 0xce 0 0xcf DISPLAY 0xd5 BACK 0xd8 SKIP+ 0xdd SKIP- 0xdf STOP 0xe0 REVERSE 0xe2 FORWARD 0xe3 TITLE 0xe5 PAUSE 0xe6 PLAY 0xea MENU 0xf7 end codes end remote
MORE SOON!